I am now accomplishing a non linear simulation, I have a panel which is positioned on to a clip, the clip in-transform is set on the beam .
Purpose of the review is to analyse the stress and deformation when a tension load is applied at the base floor. The clip and the panel will be in make contact with (i.e) the clip locks the profile as connected in the impression
As from the sample impression can notice there will be a profile overlap and the clip and the profile comes in make contact with.That’s why i utilised world-wide make contact with as “Allow for Penetration” and selected the faces in which the panel overlaps as “Bonded”
Right after producing the setup, when i operate the simulation i finish up with the mistake ” Remedy failure in the 1st Stage may possibly be because of to : (1) absence of ample Fixtures for one particular or extra pieces (2) Content Homes may possibly not be adequately described (3) Load increment may possibly be also massive or also tiny”
I been on the lookout for a option to fix this and experimented with the below techniques:
1.Checked my substance house
2. Minimized the increment time from .01 to .005 from the “State-of-the-art Solutions” from the Review attributes
3. The tension load curve also been described slowly from to 1 sec
4. Added mesh manage on the faces in which the clip and the roof are in make contact with
Can anybody assistance me, why this mistake prompts and what results in it?
Thank you for your tips