solidwork

No Comments

Resource website link

I want to set up an Admin Picture (2016 in this scenario) so that Solidworks installs only if the device is on my listing.This is my initially time executing using an Admin Picture, and I am pondering why it is really so tricky. Some concerns:

 

1. Is this a reasonable goal, something a great deal of admins would discover helpful?

 

2. Should really Solidworks make this much easier to do?

 

I identified a perform-about, but it is wearisome to apply. (I feel it was stated in a submit on the forum, but I won’t be able to discover that submit now.) For the International Options and group configurations, only eDrawings will get installed. Anyone whose device is not specified just will get eDrawings. The equipment outlined get the total bundle. Factor was, I experienced to develop these configurations for each and every device independently, and it took awhile.

 

3. Any much easier way to do it than what I explained right here?

 

In addition, it’d be awesome if I could dump in a listing of device names, rather than getting into those just one-by-just one.

 

Thanks

Dwight

Categories: Solidworks

Leave a Reply

Your email address will not be published. Required fields are marked *