solidwork

No Comments

Source link

When I decide on an location for a Split Corner in sheet metal, why will it only decide on a handful of Corners on the location and not all of them?

 

I can understand why it would not decide on inside of Corners as a Default but in the example underneath it will only decide on a single Corner out of 4 from a rectangular extruded minimize.

 

corner breaking.png

 

Has it bought a little something to do with the Features I make a decision to use. This Feature over was a flange from a sheet metal base and then an extruded minimize.

Categories: Solidworks

Leave a Reply

Your email address will not be published. Required fields are marked *